Packet Tracer – Skills Integration Challenge Routing Configure RIPv2 using the following requirements: o Do not advertise the network connected to the Internet. oĬonfigure the IP address for the subinterface according to the Addressing Table. Inter-VLAN Routing On R1 and R2, enable and configure the subinterfaces with the following requirement: o Configure the appropriate dot1Q encapsulation. Click Check Results > Assessment Items to verify you have correctly configured all items. Because this activity is checking over 150 items, not all configurations are assigned a point value. Note: Packet Tracer does not allow assigning point values less than 1. Requirements You are responsible for configuring routers R1 and R2 and switches S1, S2, S3, and S4. The PCs and Internet devices are all preconfigured. You will configure inter-VLAN routing with RIPv2, VLANs with VTP, trunking, and EtherChannel with PVST. You are responsible for configuring subinterfaces to communicate with the switches. Scenario In this activity, two routers are configured to communicate with each other. Packet Tracer – Skills Integration Challenge Packet Tracer – Skills Integration Challenge Topology
0 Comments
Leave a Reply. |